Thor-Burner

Thor-Burner

Thor-LV2D Burner-1 (Altair-3) with DMSP Block 4A F3 satellite (20 May 1965)
Function	Expendable launch system
Manufacturer	Douglas
Country of origin	United States
Size
Height	23m (75 ft)
Diameter	2.44m (8 ft)
Mass	50,000kg (110,000 lb)
Stages	2-3
Launch history
Status	Retired
Launch sites	Vandenberg AFB, LC-4300, LE-6, SLC-10W
Total launches	26
Success(es)	23
Failure(s)	3
First flight	19 Jan 1965
Last flight	19 February 1976
[edit on Wikidata]

The Thor-Burner was an American expendable launch system, a member of the Thor rocket family.^[1][2] It consisted of a Thor missile, with one or two Burner upper stages.^[1][2] It was used between 1965 and 1976 to orbit a number of satellites, most commonly Defense Meteorological Satellite Program (DMSP) weather satellites. ^[3] Twenty-four were launched, of which two failed. It weighed 51,810 kg and was 24 metres tall.

Variants

There are many Thor-Burner variations, according to the type of upper stages used:^[4]

Burner-1, MG-18 and Altair

The first two flights used a solid fuel MG-18 as second stage. After than an Altair rocket stage (same as the third stage of some Vanguard launch vehicles) was used, equipped by Boeing with 3-axis control.^[5][1]

These combinations were used for six vehicles.^[1] The first was launched 1965-01-18 and the sixth 1966-03-30. These were early launches of classified DMSP satellites. Two of these launches failed.^[6][1]

• 
  Thor-LV2D Burner-1 ( MG-18)
• 
  Thor-LV2D Burner-1 ( MG-18)
• 
  Thor-LV2D Burner-1 (Altair-3)

Burner-2

The Burner 2 used with the Thor-Burner was the first solid fuel upper-stage vehicle used for general space applications that had full control and guidance capability.^{[1][7][8][9][10]} The first Burner-2 flight was on 1966-09-16.^[11][1][7]

On February 19, 1976, the attempted launch of a DMSP satellite from Vandenberg's SLC-10W went awry when SECO occurred 5 seconds early.^[12] Although the second stage separated and fired properly, the satellite was left in an unusable orbit from which it decayed only one hour after launch. Investigation into the mishap found that the Thor had been loaded an insufficient amount of RJ-1 (a higher grade of kerosene fuel that offered enhanced performance over standard RP-1) for the mission. The amount of LOX on Thor boosters was always the same on every launch, but the amount of kerosene could vary depending on the engine, as different LR-79 engines had slightly different performance levels, and so factory acceptance data was used to determine the fuel load needed for a particular unit. The particular engine used in Thor 182 had thus been loaded with kerosene according to the data sheet provided by Rocketdyne, however the information contained a typo which led to ground crews loading too little propellant for it. However, the postflight investigation also found that, even if the correct propellant load had been carried, the mission would have still failed because the Thor did not have sufficient performance to loft the DMSP into the required orbit. As the DMSP program evolved, the satellites gradually became heavier and more complex. Program planners, aware of this, selected an LR-79 engine which had particularly high performance, but it still turned out to not be enough for the mission. The failure was thus ultimately attributed to poor mission planning.^[13]

• 
  Thor-LV2F Burner-2
• 
  Thor-LV2F Burner-2
• 
  Thor-LV2F Burner-2

Launches

There were twenty six Thor-Burner launches from Vandenberg AFB:^[4]

References

Wikimedia Commons has media related to Thor-Burner.